Motorcycle Brake Pad Motorcycle Brake Pad Lead 125 (17-20) DIO110

• [Front pad compatible models]

• Motorcycle lead 125(17-20) DIO110(15-21) DUNK(15-19) Address 125(18-20) Address 110(22) For front

• *Never use on cast iron rotors. *Two sets are required for double disc cars.

• There is no problem with the specifications, but there may be unevenness on the painted surface.

• Please check the compatible vehicle model with the actual machine before purchasing and installing it.

Brake pad for motorcycle front Warnings and precautions for use Caution ◇Motorcycle maintenance is the legal responsibility of the rider, and periodic inspections and maintenance are not necessary. Be sure to carry out regular inspections as well as daily inspections. ◇ Never use cast iron disc rotors. ◇ If shims are attached to the genuine pads, please use them at the same time. If the shim is bent or damaged, replace it with a new one. ◇ Be sure to replace the friction material when the remaining thickness reaches 2 mm. ◇ If you suspect that an abnormality has occurred while driving, immediately stop the vehicle in a safe place and inspect the abnormality. ◇ After replacing the brake pads, check to see if the brakes are working properly and run them for about 100-200km to ensure they feel comfortable. ◇Please check the compatible car model with the actual machine before installing. warning ◇Please be sure to request a mechanic from a certified equipment factory to carry out the installation work. ◇If the disc rotor is damaged, replace it. ◇When replacing the brake oil, be sure to check that the amount of brake oil meets the specified amount and that air is not mixed in. ◇After replacing the pads, check that the caliper piston is working properly. This can cause brake drag and abnormal premature wear or uneven wear of the pads. ◇ When performing installation work, be sure to check that the brakes are cool. ◇Be sure to replace the left and right pads as a set, as this may cause the pads to wear out. ◇ Do not use parts other than the compatible model. ◇ After installation, be sure to inspect each part and retighten.After that, be sure to perform an inspection and retighten the same parts every 500km.