0.3-6L / Min DC 5-18V Hall Effect Water Flow Sensor Switch for Heating, Imprinter, Automatic

Feature:

The water flow sensor is applied for water heater, imprinter, automatic water machine, and other flow metering equipment.

With stainless steel ball inside of the impeller, wear-proof

Up and down structure stress applied for the seal , avoid to leak

with imported Hall element, and adopt pouring sealant encapsulation to avoid to leak and age

Install vertically, angle of inclination should not be exceeded 5 degree

Medium temperature should not be exceeded 120degree

Wiring:

Red - In - Connect positive

Yellow - Out - Signal output

Black - GND - Connect negative

Technical Parameters:

Working range: 0.3-6L/min

Water pressure: ≤0.8MPa

Minimum rated working voltage: DC4.5 5V-24V

Maximum working current: 15 mA（DC 5V）

Working voltage range: DC 5～18 V

Load capacity: ≤10 mA（DC 5V）

Operating temperature range: ≤80℃

Operating humidity range: 35%～90%RH (no frost)

Storage temperature: -25～+ 80℃

Storage humidity: 25%～95%RH

Size (L x W x H): Approx. 5.8 x 3.4 x 2.7cm / 2.28 x 1.34 x 1.06 inch

Output interface diameter: Approx. outer 7mm, inner 3mm

Package Includes:

1 x Water Flow Sensor Switch Meter Flowmeter Coffee Dispenser Counter