K2 RED SILICONE 300g High Temperature +350°C

High-quality silicone. Perfectly adapts to sealed surfaces. Resistant to high temperatures up to +350°C. Meets the requirements of car manufacturers (O.E.M. - Original Equipment Manufacturer). Replaces traditional gaskets: cork, paper, felt, asbestos and rubber.

Thanks to the SENSOR SAFE formula, it is safe for lambda sensors used in modern cars with electronic fuel injection. Resistant to: oils, greases, coolants, etc. Can be used for all car models and brands, including: for sealing: valve covers, thermostat gaskets, oil pans, camshaft covers, water pumps, rear axle covers and many other components requiring tightness and resistance to high temperatures.

1. The surface must be dry, clean of dust, dirt, grease and remnants of the old seal.

2. Spread a small amount of silicone on the surface.

3. Remove any excess using, for example, a knife dipped in soapy water. The sealant begins to dry after 5 minutes and is touch-resistant after 1 hour. Fully hardens after 24 hours.

4. Excess hardened silicone can be removed with a sharp tool.

5. Close the tube after each use.