Label:Yes
Material: Polytetrafluoroethylene, Fiberglass, Silicone
Name: PTFE Tape
Thickness: 0.13mm
Length: 10m
Width: 10/20/30/40/50/80/100mm
Features:
1. Anti-stick: The surface is smooth and not easy to adhere to any substance. Easy to clean all kinds of oil stains, stains or other attachments attached to its surface; almost all sticky substances such as paste, resin, paint can be easily removed.
2. High temperature resistance: This product is resistant to high temperature of 330 ° C, and the surface of the tape is made of Teflon (ie PTFE) with good anti-sticking, smooth and wear-resistant. The silica gel on the back is resistant to high temperature, and the paste is firm and will not peel off. long lasting.
3. Easy to use: No need to disassemble and transport the drying cylinder, just stick the anti-stick tape to the surface of the drying cylinder and it can be used normally.
4. Protect the equipment: greatly reduce the labor intensity, and is also conducive to the protection of the equipment. The downtime is short, the comprehensive cost is low, and the economic benefit is high.
5. Features: high insulation performance, anti-ultraviolet, anti-static, fire retardant, long service life.
6. Multipurpose Use: It can be applied to packaging sealing machine, Impulse Sealer, hot melt machine, motor, high and low voltage electrical products, wire and cable insulation protection, battery manufacturing sewing machine and so.
Application Scenarios:
1. Insulation of wires, cables and coils (for Type H electrical insulation)
2. Feeding lining material
3. Sliding material for rails
4. Isolation material for heat sealing
5. Prevent adhesion of glue and stickers
6. For the removal of wood molds and plastic forming dies
7. Paper feeding tape for fax machines
8. Copier rails
9. Gasket lining material
10. Gaskets that are exposed to corrosive chemicals
11. Lining of various mechanical sliding surface
12. etc
Usage Method:
1) Simply remove the tape on your current heating element (make sure to get the residue from the old tape off).
2) Cut your new replacement tape to the correct size.
3) Remove the yellow backing from the tape and place over the heating element (under the element if using for an impulse sealer). Smooth out the tape with your finger as you go, to ensure a good bond.
Package Including:
1 x 10M/Roll PTFE Tape
No-delivery refund
